collapse

Author Topic: C125 Pump Options  (Read 1256 times)

0 Members and 1 Guest are viewing this topic.

Offline conc2steel

  • Officers
  • Forum Member
  • **
  • Location: Raeford, NC
  • Posts: 98
    • NC Hydroseeding
C125 Pump Options
« on: Wed September 09, 2020, 08:08:08 PM »
I'm looking at purchasing an '08 C125 with a bad pump.  Is it possible to switch this to a Bowie Gear or other builder Vortex pump?  If so what's required (other than a new pump/mount) to enable it?
Finn T-330, Finn T-120, Bowie 1100, Kincaid 1200 Pro

Offline Turboguy

  • Administrator
  • Forum Legend
  • *****
  • Location: Beaver Falls, PA
  • Posts: 5987
  • Beaver Falls, PA
    • Turbo Turf HydroSeeding Systems
Re: C125 Pump Options
« Reply #1 on: Thu September 10, 2020, 05:48:16 AM »
I have a little more experience with centrifugal and gear pumps than vortex pumps.  For the most part if the inlet and outlet lines are properly plumbed, the unit is securely mounted and the input shaft is turning in the right direction and somewhere close to the right speed you should not have an issue.

One thing to check.  Centrifugal pumps usually have an input speed about the same as the engine RPM.  Bowie gear pumps, however, need the input speed not to exceed 400 RPM.  I am not sure if the input for the pump on your C125 is geared down or not but it is one more factor to consider.
Turbo Turf HS-400-XPW

 

* Recent Posts

Re: Wood Fiber TT 300 XPW by Turboguy
[Wed November 16, 2022, 08:24:45 PM]


Re: Wood Fiber TT 300 XPW by dementor4842
[Wed November 16, 2022, 12:18:45 PM]


Re: Wood Fiber TT 300 XPW by Turboguy
[Wed November 16, 2022, 11:34:39 AM]


Re: Wood Fiber TT 300 XPW by dementor4842
[Tue November 15, 2022, 04:07:08 AM]


Re: Wood Fiber TT 300 XPW by Turboguy
[Thu November 10, 2022, 12:02:23 PM]

* Calendar

November 2022
Sun Mon Tue Wed Thu Fri Sat
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 [29] 30

SimplePortal 2.3.6 © 2008-2014, SimplePortal